Piet de Necker props

Australian designed and manufactured Jabiru Aircraft/

Moderator: Moderators

User avatar
BigglesSA
Fower Tousand
Fower Tousand
Posts: 4357
Joined: Sat May 03, 2008 4:09 pm
Has liked: 19 times
Been liked: 5 times

Re: Piet de Necker props

Unread post by BigglesSA » Thu Aug 30, 2012 11:12 am

Ai Aldo you need a break! In your plane!
Groetnis
Francois Gouws
“I fly because it releases my mind from the tyranny of petty things. ” Antoine de Saint-Exupéry“
User avatar
abezzi
1k poster
1k poster
Posts: 1462
Joined: Wed Apr 30, 2008 3:20 pm
Closest Airfield: Maun
Location: Maun
Has liked: 6 times
Been liked: 4 times

Re: Piet de Necker props

Unread post by abezzi » Thu Aug 30, 2012 2:49 pm

Ops... :roll:
Piet propeller
Tripped over wheel chock
Posts: 26
Joined: Sun May 04, 2008 9:13 pm
Has liked: 8 times
Been liked: 19 times

Re: Piet de Necker props

Unread post by Piet propeller » Mon Dec 17, 2018 8:58 pm

This propeller comes from a 360hp V-8 engine and was made by SENSENICH in the '60s. It was used for hundreds of hours in Botswana in the Okavango swamps for research, fun, gill net wrecking, exploration, anti-poaching, fishing and so forth. The boat travels, in 3-meter reed beds at close to 105 KPH, and on water at about 130 KPH. The propeller shown here was brought in for reproduction. The propeller needed extensive repairs, cracks filled and sanded to prepare it for a 3 dimension scan. The scanner gathers data points in an x, y and z-axis, so 3 dimensions. The scanning takes about 8 to 12 hours of very precise alignment steps to ensure that overlapping sections do not curl up or down but aligns perfectly. After the scanning procedure the file, which are tens of Megabytes large, is imported into a 3D CAD/CAM program for editing purpose. The scanner will pick up and record even the tiniest of hairline cracks or abnormalities. The CAD program is used to smooth out, adapt and edit the scanners results. This is done so that the file can be read by a CAM program and a cut file is generated ready to be interpreted by the motion controllers of the CNC router table.
You do not have the required permissions to view the files attached to this post.
User avatar
ZuluBen
Six Tousand
Six Tousand
Posts: 6593
Joined: Mon May 09, 2005 4:54 pm
Location: Gaborone, Botswana
Has liked: 3 times
Been liked: 3 times

Re: Piet de Necker props

Unread post by ZuluBen » Mon Dec 31, 2018 5:34 pm

Lekker Piet!

Show when done please! 8)

Return to “Jabiru”