Phantom 3 Pro advice needed

[FHV]

I have a DJI Phantom 3 Pro which I have not flown for more than two years. Recently I fired it up and found that though the drone flies from the TX, I cannot link the android tablet that I always used and get no picture (have tried other android devices but the same thing happens). Does anyone have any suggestions ? Could it be that my software is so outdated that it doesn't "see" the drone anymore ? I have tried deleting the App off the tablet and reloading it but that doesn't make a difference.

It may be relevant that about three years ago I got Drone World to install a "long range " antenna (total waste of time and money!) which I used for about six months before getting gatvol of lugging the now bulky TX around and I stopped flying the drone.

Before I tried flying again recently I took the "long range" piece of cr@p off and refitted the original bunny ear antennas. Maybe the TX needed re-configuring afterwards ??

I'm loath go back to the crowd that sold me the "upgrade" because I'm annoyed that they sold me a system that they promised would give me six km range and all it did was increase my range by 400 m despite going back to them three or four times, this apart from all the other stuffing around I was subjected to. (I wanted the long range because I wanted to use the drone off my boat far out at sea for finding gamefish -tunny etc)

Any suggestions or point me in the direction of someone in Cape Town (not DW) who can sort it out?
Francois
Oh ate 29550458

[Ricoby]

If you using the original cable, tablet, etc. it should work. Don't use DJI GO 4. That won't work with the Phantom 3.